|
1951 Chevy Accessories Installation Manual |
|||||
 |
|||||
|
|
|||||
|
Figure
194 |
|||||
|
|
|||||
|
Model Series
All 3000
Series
All 4000-6000
Series
All 5000
C.O.E. |
Measurement at A
17-5/16"
20-1/2"
17-5/8" |
Measurement at B
8-1/8"
9-7/16"
3-1/16" |
bar as
shown in figure 193. Tape the left-hand wire to reinforcement plate and
through existing headlamp
grommet and run the left and
right-hand wires along existing wiring harness to the three way connectors and
clip to wiring harness as shown
in figure 193.
4. Place rear lamp wires in three way
connectors and follow
truck wiring along frame to rear
lamps.
5. Rear lamp mountings will vary with the type
body used on the truck.
Instructions for the most
popular body types are shown in the following figures:
Pick-up
body figure 197. Panel body figure 200. Platform body figure 198. Cab and Chassis figure
199.
Approximate Flat Rate Time 1.3
hours. |
||
|
See figures 192 and 193 for "A"
and "B" locations. After locating lamp positions drill 7/16 inch hole on
crown of fenders. Place wire of each lamp through fender and install the
flat washer, lockwasher and nut and tighten lamps securely. The right-hand
lamp wire should be taped to reinforcement plate of the fender as shown in
figure 195. Pass the wire through the existing headlamp grommet in fender skirt and clip to radiator
tie |
|||||
|
|
|||||
 |
|||||
|
|
|||||
|
Figure 195 |
|||||
|
|
|||||
|
82 |
|||||
|
|
|||||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|