1951 Chevy Accessories Installation Manual

tmp349-1.jpg
tmp349-2.jpg
Figure 118
ator tie bar. Place left-hand lamp wire through fender skirt and splice right-hand wire into left-hand wire, solder and tape as shown in figure 117.
Place left-hand lamp wire along truck wir­ing harness and run through dash to drivers compartment. Install fog lamp switch to in­strument panel as shown in figure 119. Place rubber sleeve and terminal on wire from fog lamps and connect to terminal marked "FOG" on switch as shown in figure 119. Place #16 natural colored jumper wire from
Figure 116
3. Place right-hand lamp wire through fender skirt with parking lamp wire and through clips holding truck wiring harness to radi-
tmp349-3.jpg
Figure 117
47