|
1951 Chevy Accessories Installation Manual |
|||
|
SEAT COVERS
Procedure
for Installation of All Types of Seat
Covers on
Four-Door
Sedans. (Fiber - Plastic -
Rayon)
1. Remove rear seat cushion and
back rest from
car.
REAR SEAT BACK REST
1. On deluxe models remove top trim rail from
back rest. NOTE: "Special"
models not equipped with trim
rail.
2. Place seat cover over back rest and line up
seams with contour of back
rest and hog ring as shown in
Figure 14.
3. On deluxe models replace trim rail and
reinstall back rest in
car. |
 |
||
|
Figure 16 |
|||
 |
|||
 |
|||
|
Figure 17
side,
cover may be torn. Line up all seams
to follow
contour of back rest.
Place "S"
hooks in elastic tabs on front side
of back
rest cover and close "S" hook on
elastic
tabs with pliers as shown in Figure
18. |
|||
|
Figure 14
REAR SEAT CUSHION
1. Place seat cover over seat cushion and line
up seams and floor tunnel
"cutout," hog ring as shown in
Figure 15.
2. Replace rear seat cushion in
car. |
|||
 |
|||
 |
|||
|
Figure 15 FRONT SEAT BACK
REST
Remove robe cord and ash tray as
shown in Figure 16. Place seat cover
over back rest and work down
evenly about two inches on each side at a time (THIS IS IMPORTANT),
see Figure 17. If pulled down too far
on one |
|||
|
Figure 18
3. Place
"S" hooks in seat frame as shown in Figure 19. |
|||
|
|
|||
|
9 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|