1951 Chevy Accessories Installation Manual

tmp1CA-1.jpg
as shown in Figure 25.
3. On deluxe models replace trim rail and re­install back rest in car.
REAR SEAT CUSHION
1. Place seat cover over seat cushion and line up seams and floor tunnel "cutout" hog ring as shown in Figure 26.
tmp1CA-2.jpg
Figure 23
tmp1CA-3.jpg
Figure 26
2. Replace rear seat cushion in car. FRONT SEAT BACK REST
1. Remove robe cord as shown in Figure 27.
Figure 24
Approximate Flat Rate Time 1 hour. SEAT COVERS
Procedure for Installation of
All Types of Seat Covers on
Two-Door, Bel Air and Convertible
(Fiber - Plastic - Rayon)
1, Remove rear seat cushion and back rest from car.
REAR SEAT BACK
1.    On deluxe models remove top trim rail from back rest. NOTE: "Special" models not equipped with trim rail.
2.    Place seat cover on back rest and line up seams with contour of back rest, hog ring
tmp1CA-4.jpg
Figure 27
2. Place seat cover over back rest and work down evenly, about two inches on each side
tmp1CA-5.jpg
tmp1CA-6.jpg
Figure 25
Figure 28
11