|
1951 Chevy Accessories Installation Manual |
|||
 |
|||
|
|
|||
|
Figure 145 |
|||
|
|
|||
|
2. Install rear view mirror clamp assembly
with screw previously removed
from mirror assembly, (see
figure 145).
3. With pad in place under base of mirror,
install mirror on top of
door with center of base located above rear edge of division channel, (see figure 145), and insert clamp
between rubber door seal. Tighten set, screws.
4. Adjust
angle of mirror to suit.
5. If additional adjustment is desired remove
mirror from door and adjust
clamp on mirror arm by
loosening screw and rotating to desired
position. |
 |
||
|
Figure 146
1. Place the two clips on the mirror over the
right-hand sun visor and
center mirror on visor as
shown in figure 147.
2. Wrap wire around visor arm and bracket,
allowing sufficient wire to
permit visor adjustment
as shown in figure 147.
3. Pin wire to pillar trim, using the three
pins provided. |
|||
|
Approximate Flat Rate Time .2
of an hour. |
|||
|
986439 VANITY VISOR MIRROR
Procedure
for Installation of Vanity Visor Mirror on All Model Passenger
Cars. |
|||
|
|
|||
|
61 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|