|
1951 Chevy Accessories Installation Manual |
|||
 |
|||
|
|
|||
|
Figure 147 |
|||
|
|
|||
|
NOTE: Pin
as close to door weather seal as
possible to conceal the wire,
4. Place wire between end of instrument panel
and pillar trim as shown in
figure 147.
5. Place wire into
rolled flange along rear edge of
instrument panel and into clips provided. Attach ground wire
under clip attaching bolt,
6. Attach fuse holder to open terminal of
Accessories Junction
Block. Tape mirror wire to
wiring harness as shown in figure 147.
Approximate Flat Rate Time .2
of an hour. |
1. Raise hood and remove the two nuts and
washers holding the equipment
ornament and remove from
car,
2. Place accessory ornament into existing two
holes in hood, and replace
washers, nuts and tighten
securely.
Approximate Flat Rate Time .1 of an hour. 986161 HOOD ORNAMENT - COMMERCIAL Procedure
for Installation of Hood Ornament on
3000 Commercial Model Trucks. |
||
|
|
|||
|
986528 HOOD ORNAMENT
Procedure
for Installation of Hood Ornament on
All Model Passenger Cars. |
 |
||
 |
|||
|
|
|||
|
Figure 148 |
Figure 149 |
||
|
|
|||
|
62 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|